Configuring the Linear Gain block

1. To open the block property page (the page on which the block configuration is specified), either double click on the block or right-click on the block and select Block Properties.

2. To apply a linear gain to a single field, single click twice (or single click once and then press F2) on the value in the A list then type the correct value in its place.  To set the same linear gain value for all fields; enter the value in the A Constant edit box then click the Apply to All button next to the A Constant edit box.

3. To apply an offset to a single field, single click twice (or single click once and then press F2) on the value in the B list then type the correct value in its place.  To set the same offset value for all fields; enter the value in the B Constant edit box then click the Apply to All button next to the B Constant edit box.

4. To change an output field name; select the output field in the Output fields list-box on the right, click on the field again or press F2 then type a new field name.

5. To add a postfix to the output field name, enter the postfix in the PostFix edit box, then press the Apply to All button next to the PostFix edit box to append the post fix to each output field name.

6. To remove a postfix from the output field name, enter the postfix in the PostFix edit box, then press the Remove from All button next to the PostFix edit box to remove the postfix from each output field name.

7. Click Apply to accept changes or OK to accept changes and close the block property page.

Return to top

Related topics:

• Linear Gain block