Model 650-Event Conformance \ Test Percentage Complete
Model 650 Description
Model 650 is used to calculate conformance data for specified variables for specific events. It also calculates the Testing Percentage Complete data for each variable specified.
The functionality in this model is available only if you have purchased the Quality Module.
Model 650 Properties
The following Model properties are set up using the Plant Applications Administrator:
Property |
Description |
Maximum Run Time (Seconds) |
optional: Type the number of seconds you want the model to run. The default is 0 (zero), which means the model will not time out. Typically, you will want to limit the run time of the model only if troubleshooting the model (for example, one of the stored procedures is in an infinite loop). |
Model Processing Group |
Used for multithreading. See the Multithreading topic for more information. |
TINT:Interval (Minutes) |
Timing interval the model fires. |
Variable Update Delay (seconds) |
This is the minimum number of seconds between recalculations. If the previous calculation was done less than this amount of time ago, then the calculation doesn't get fired. This must be set to a value greater than 30 seconds |
Cache Reload Window |
This is the number of seconds that the specification cache for a product will remain valid. After the specified number of seconds expires, the cache will get reloaded. |
See Also