Third Quarter of 2018

This topic provides a list of product changes released for this module on the dates listed below.

Release Date: September 21, 2018

Table 1. Enhancements and New Features

Note	Tracking ID(s)
To enhance usability, you can now change the value in the Error Assessment field from Percent of Range to Engineering Units and vice-versa in the following calibration templates: Calibration Template, Analog Calibration Template, Discrete To facilitate this enhancement, the following changes have been implemented: The Error Assessment field has been added to the Calibration Template, Analog and Calibration Template, Discrete datasheets. The Max Error Limit or Engineering Units Error Limit field is enabled based on the value selected in the Error Assessment field in the template. When you access Calibration, Analog or Calibration, Discrete records, the Error Assessment field is disabled and populated from the template that is linked to the calibration. The Calibration Error Limit or Engineering Units Error Limit field is enabled based on the value in the Error Assessment field in the Calibration record.	US273397 US273395
To enhance usability, you can now enter the exact value of the error limits in engineering units in the following calibrations: Calibration Results, Analyzer record linked to a Calibration, Analyzer Single Component record Calibration Results, Analog record in Weight Scale Calibration To facilitate this enhancement, the following changes have been implemented: When you access calibration templates, either the Max Error Limit or Engineering Units Error Limit field is enabled based on the option selected in the Error Assessment field. When you access calibration results, the As Found and As Left values now appear in engineering units only if the value in the Error Assessment field in the Calibration record is Engineering Units. New fields, Eng. Unit AF Error and Eng. Unit AL Error, have been added to the Calibration Results, Analyzer family. A new field, Engineering Units Error Limit, has been added to the Calibration Template, Single Component Analyzer and Calibration Template, Weight Scale families. The Error Assessment and Engineering Units Error Limit fields have been added to the Calibration Template, Single Component Analyzer and Calibration Template, Weight Scale datasheets.	US266110 US266102
The amplitude peak-to-peak voltage has been set to 5VDC for the frequency-sourced calibrations. This enables Fluke 74X and 75X to generate wave forms with 5VDC amplitude when you send data to the device.	US266086

Table 2. Resolved Issues

Note	Tracking ID(s)
Previously, every time you navigated away from the Calibration Queue section and then accessed it again, the dates in the Due Date Range box were erroneously updated, although they appeared correctly in the UI. As a result, additional records appeared if calibration tasks existed for the new date range. This issue has been resolved.	DE87327
Previously, in the Download Calibration Checklists section of the Receive From Device window, after receiving data from the Fluke calibrator, in the Data subsection, the status of the records received was incorrectly displayed with the number of records sent to the calibrator instead of the number of records received. This issue existed when the calibration was not completed on the Fluke device. This issue has been resolved.	DE82721
Previously, in the Identification section of a Calibration Event datasheet, you could add a value in the Cylinder ID drop-down list box even if it did not match the ID of a Standard Gas Cylinder. This issue has been resolved. Now, you must select an existing option in the Cylinder ID box, which contains only the Cylinder IDs of existing Standard Gas Cylinders.	DE82499
Previously, when you switched from the Calibration Profile datasheet to another page, and then returned to the same Calibration Profile datasheet, the Link Asset(s) button () and the Search button () that previously appeared in the Linked Assets section no longer appeared. This issue has been resolved.	DE81983